White's Farm Supply
Canastota
(315) 697-2214
4154 State Route 31
Canastota, NY 13032
Call Us
Directions
Franklin
(607) 829-2600
387 Center Street
Franklin, NY 13775
Call Us
Directions
Lowville
(315) 376-0300
8207 State Route 26
Lowville, NY 13367
Call Us
Directions
Schaghticoke
(518) 753-2237
1205 State Route 40
Schaghticoke, NY 12154
Call Us
Directions
Waterville
(315) 841-4181
962 State Route 12
Waterville, NY 13480
Call Us
Directions
Shop Parts

Stihl HT 56 C-E

New Equipment / All Lines / Stihl / Sawing & Cutting / Pole Pruners / Homeowner Pole Pruners / HT 56 C-E

Double tap to zoom

 

Features

  • Built in the USA
    A majority of STIHL gasoline-powered units sold in the United States are built in the United States from domestic and foreign parts and components.
  • Reduced-Emission Engine Technology - Caring for Nature
    The STIHL Inc. “Caring for Nature” seal identifies its powered products that are more environmentally conscious, producing zero or low exhaust emissions. STIHL Inc. defines “low exhaust emissions” as being cleaner than EPA and/or CARB exhaust emission standards.
  • Unique Two-Piece Shaft Design
  • This unique shaft design provides easy storage and transport.
  • STIHL Easy2Start™
    The STIHL Easy2Start™ system makes starting STIHL® outdoor power tools almost effortless, eliminating the need for a strong pull of the starting cord. This advanced starting system is designed to make starting STIHL® products fast and easy. The specific system may vary by model, but in each case, a quick pull overcomes the engine’s compression to minimize the strength and effort required to start. Available on selected products.

Specifications

POWER SOURCE Gas
GUIDE BAR LENGTH (Recommended) 10 in.
OILOMATIC® CHAIN 1/4" PM3
CHAIN OIL CAPACITY 4.1 oz.
OVERALL LENGTH 110.4 in.
ENGINE POWER 1.07 bhp
FUEL CAPACITY 11.5 oz.
DISPLACEMENT 1.66 cu. in.
WEIGHT 12.8 lbs.
Note: Weight displayed is dry weight including cutting attachment. Compatible guide bar lengths: 10" to 12". The actual listed guide bar length can vary from the effective cutting length based on the gear head design.